 |
|
|
|
|
|
|
|
|
|
 |
|
||||||||
 |
 |
 |
 |
 |
 |
 |
|
||
 |
 |
 |
 |
 |
 |
|
|||
 |
 |
 |
 |
|
|||||
 |
 |
 |
 |
|
|||||
 |
 |
 |
 |
|
|||||
DAY 4 - 7
|
|
| Elevators with the leading and trailing edges installed, shaped and sanded |  |
| Rudder with leading and trailing edges in place |  |
| Wings with leading and trailing edges |  |
| Elevators with the cut lines drawn on them. I made them 3/8" smaller (stab larger) than the plans call for since you use such a small amount for pattern and still have plenty for 3D |  |
All the control surfaces cut (on the table saw except for the little piece in the corner) Rudder was left the size Carden says to make it |
 |
| Cutting the bevels on the table saw. By using the table saw, I know exactly how much throw I will have due to the angle of the blade. |  |
| Elevator with the bevels drying |  |
| Another shot |  |
| Wings and ailerons after the bevels have dried and sanded flush to the surface |  |